Steve, 
Suppose you got a small shop and a NC with a high speed diamond drill chuck.
Then just take a round POM bar or like, cut into discs, take connector
drawing data and put into NC register, and alas...spit out so many you
want..if you don't have pin positions, a friend with an optical measure
machine will give you data in five minutes..

Inge

-----Ursprungligt meddelande-----
Från: TechNet [mailto:[log in to unmask]] För Steve Gregory
Skickat: den 4 mars 2008 20:37
Till: [log in to unmask]
Ämne: [TN] Circular Mil Connector Installation Problem...

Hi All!
 
I've got some ladies in our slide operation wanting to take some of us
engineers out to be drawn and quartered because we're asking them to
install a mil connector into an assembly without alignment disks. If any
of you have worked with these connectors, you know what I'm talking
about. 
 
Here's a picture of a connector with an alignment disk:
 
http://stevezeva.homestead.com/files/Disk_on_Connector.jpg
 
And here's the one that has the blood shooting out the eyes of the
ladies on our slide line:
 
http://stevezeva.homestead.com/files/Connector_without_Disk.jpg
 
These connectors did not come with alignment disks. As you can see,
they're from one of the few companies that make these connectors. So I
called them and asked them to quote me what it would cost for the
alignment disks for these connectors, and get this; $55.43 EACH (in
qty's of 50-999) with a 12-WEEK LEAD TIME! They do this because they
can...sheesh!
 
So, I'm wondering if any of you out there has a some trick or gizmo that
will aid in installing these connectors? By the way, the leads can't be
trimmed on a bias because the connector is stood off the board so high
that we just have lead protrusion...
 
Steve

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------