Subject: | |
From: | |
Reply To: | |
Date: | Thu, 7 Feb 2008 16:29:54 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Inge I am almost embarrassed to mention this but have you considered using
solder wire non cored and hold it in position with some tac flux??
Kindest regards
John Burke
(408) 515 4992
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Hfjord
Sent: Thursday, February 07, 2008 9:32 AM
To: [log in to unmask]
Subject: [TN] absolutely crazy dispenser question
Hi all,
I have 100 mm long tube, quadratic cross section about 15x15 mm. It's made
up by 4 pcs double copper sided 'boards' put together to form the tube. I
need dispense solder paste on INSIDE in all for corners and all along the
100 mm length. Now, have you seen dispenser robotics with syringes that
long? I would like to dispense in all four corners simultaneously, but that
is probably to be a dream only.
No, I can't buy ready to use molded stuff, or other tubular things, nor
cut-and-wrap, or any else products. The 4-piece design is given and
unchangeable. And..I can't print solder paste on the individuals for later
putting together.
/Inge
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|