Subject: | |
From: | |
Reply To: | |
Date: | Thu, 20 Dec 2007 14:50:10 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Try your local blueprint and drafting supply outlet. The "Grey Grinding
Bars" we made to remove the emulsion from Sepia and Mylar copies.
Jeffrey McGlaughlin, CID
Engineering Designer
Battelle
505 King Avenue
Columbus Ohio 43201-2693
(614)424-7582 Phone
(614)458-7582 Fax
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Gervascio, Thomas
Sent: Thursday, December 20, 2007 2:04 PM
To: [log in to unmask]
Subject: [TN] Erase to abrade off HASL off circuit cards
We have a requirement to use an erase to remove solder from a PCB pad
down to the base copper. The recommended erase is too soft- we found a
hard grey abrasive erase that goes in an electric eraser but don't know
where we can buy more of these. Any ideas?
Tom Gervascio
Principal Process Engineer
Sypris Electronics
Desk/VoiceMail 813-972-6763
Beeper 813-887-0098
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|