I have a small panelized SMT SIM module with gold fingers that I was
going to use ENIG for the entire board including the gold fingers.  I
was not going to use the standard gold tip process.  This board only
requires one or two insertions.  Once it is installed most likely it
will never be removed from the socket.  I've done this on a similar
board with no issues but wanted some feedback from my fellow
Techneter's.

 

Thanks in advance,

 

Scott 

 


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------