Hi,

I found out I'm calling out a somewhat generic note for my soldermask:

"...APPLY GREEN LIQUID PHOTO IMAGEABLE SOLDER MASK PER IPC-SM-840, CLASS
H..."

Then we are spraying the boards using Tech Spray Fine-L-Kote, 2102,
Silicone Conformal Coating.

Is there a better way to specify my board soldermask that will not cause
compatibility issues with this type of conformal coating?

Or is my concern a non-issue?

Thanks a bunch.

Regards,

Bob Wilson
E/M Designer, CID+
SpectraSensors, Inc.
11027 Arrow Route
Rancho Cucamonga, CA 91730
(909) 948-4110
www.spectrasensors.com
www.ipc.org
 
  


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------