Have you tried contacting the vendor or a technical rep?  
Once upon a time I had a matrix of time/temp for a given thickness of
1A33. Unfortunately it is long gone.
I do know that for some of our product 1.5 hours at 200F was all we gave
it. We also had a product that we baked for a minimum of 8 hours before
sending on. 
The thing about 1a33 is that it is an oxygen cure, so time is one of the
best ways to cure it. If the product does not need full properties right
away you can get away with a partial cure, and leave time do the rest.
As I remember, for about 3 mils of coating a 1 week of cure time was
required.
If the product has a high impedance circuit that is tested right away,
or goes straight to humidity testing, you will need the longer bake out.

Be careful about higher temperatures. You start to risk damage to the
electrolytic capacitors. 

-Mike


-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Graham Collins
Sent: Thursday, November 01, 2007 12:01 PM
To: [log in to unmask]
Subject: [TN] curing my conformal coating

Hi TechNet
Having a production time crunch, the usual question is being asked of me
- "Do we have to cure the coating for THAT long????"

So - any coating gurus out there (Graham N, are you there?):
 - Humiseal 1A33, per the spec sheet, minimum cure is 20 hours at 190F
(87.8C).
Is it possible to cure at a higher temperature for less time, without
compromising the performance of the material?

Thanks!
 - Graham Collins

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------