Subject: | |
From: | |
Reply To: | |
Date: | Fri, 9 Nov 2007 16:23:00 +0100 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Dear Technetters,
We had two boards out of 25 with a nonwetting problem. After reflow there was no solder on the flashgolden pads. Instead all the solder had gone to the leads of the 0805 capacitor.
Our pcb producer comes with the following conclusion:
"Our Q-dept. just informed me that they did x-ray inspection of the 2 boards you sent us back recently. Apparently there have been components used which contain up to 20% lead. During reflow-soldering the tin-lead on those components will melt first and absorb all the solder paste even before the tin which is included in the solder paste will melt. A golden flashgold pad without any tin will be the result. The tin will accumulate on the components and create those solder-balls instead.
In a second test we did lead-free soldering on the side which contains no components. The two PCBs showed excellent tin-wetting on this side. All pads – big and small ones – are nicely covered with tin. So basically we will reject any complaint - the boards are ok."
Does this make sense?
Regards,
Lon Weffers
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|