Good morning,
One of our engineers posed this question;
" I have an inner ground plane in an area with high voltage (to 600 V).
My question is this: What is the recommended spacing between the
plated-though hole with this voltage and the internal ground plane
relief outline? I will go with 10 V/mil as a default, but I am hoping
the safe limit might be a bit higher than this."
Can you point me to an IPC spec for this? I was thinking it might be in
2222.
Thanks in advance.
Phil
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------