Depends on exactly what you need.  The are Carlson pins, I buy those 
through DJB here in California.  these are SS flat base tabs with a pin in 
one corner, many diameters and heights.

Or ACT in some barn in New England makes custom pins, almost anything you 
want.  I have a brochure somewhere. 

if you want phone numbers drop me a note.

Chuck Brummer
3M Manufacturing Engineer
8357 Canoga Ave.
Canoga Park, CA 91304-2605
(818) 734-4930




Blair Hogg <[log in to unmask]> 
Sent by: TechNet <[log in to unmask]>
09/07/2007 09:28 AM
Please respond to
TechNet E-Mail Forum <[log in to unmask]>; Please respond to
Blair Hogg <[log in to unmask]>


To
[log in to unmask]
cc

Subject
[TN] Tooling Pins






I'm looking for a good source of tooling or locating pins to hold a PCBA 
in place for soldering or testing. The best I can find is McMaster-Carr, 
and they have limited options to use in the holes for #4 screws. 

Any Technetters out there with better sources for tooling pins?

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to 
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to 
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 
for additional information, or contact Keach Sasamori at [log in to unmask] or 
847-615-7100 ext.2815
-----------------------------------------------------



---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------