Subject: | |
From: | |
Reply To: | |
Date: | Thu, 6 Sep 2007 10:04:06 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Dear Technetters,
Are there some distinct set of considerations that apply only to backplane PCBs? A question was raised regarding the suitability of ENIG finish for backplane assemblies. We are using ENIG for other PCBs and so far, have not run into issues that can be traced back to the ENIG finish. What are some unique considerations that must be taken into account when specifying a finish for a backplane assembly?
Thanks in advance,
Amol
CONFIDENTIALITY NOTICE:
This e-mail, and any attachments, is for the sole use of the intended
recipient(s) and may contain information that is confidential and
protected from disclosure under the law. Any unauthorized review, use,
disclosure, or distribution is prohibited. If you are not the intended
recipient, please contact the sender by reply e-mail, and delete/destroy
all copies of the original message and attachments.
Thank you.
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|