Subject: | |
From: | |
Reply To: | |
Date: | Wed, 5 Sep 2007 20:40:29 +0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hello,
While soldering SMD passives (0805, 1206 packages) onto Tin/Lead finished board, the operator noticed the solder bubbles as it melt. On further heating, the good solder fillet is formed between the termination and the solder pad. However, a tiny "dimple" is left in the centre of the solder joint. While not all has tiny "dimple" left behind, bubbles do occur during most of the operation.
What could be the cause as there is no change to the material used (solder, flux, soldering iron, etc)?
Sometimes back, someone asked about blowholes and the cause is that it is due organics in electroplating. As my board is Tin/lead finish, is the cause the same?
Thanks and regards,
Wee Mei
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|