Subject: | |
From: | |
Reply To: | |
Date: | Wed, 11 Jul 2007 15:08:22 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
The AIM technical data sheet says:
CLEANING
264-5 can be cleaned, if necessary, with saponified water or an appropriate
solvent cleaner. Please refer to the
AIM No-Clean-Cleaner Matrix for a list of suitable le cleaning materials.
I don't think your process is appropriate
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Tom P. Hummel
Sent: Wednesday, July 11, 2007 2:50 PM
To: [log in to unmask]
Subject: [TN] No Clean flux residue after water wash
Fellow TechNetters,
We are experiencing a white residue on the solder side of some boards after
going through our wash system. We are wave soldering the boards on a SeHo
wave solder machine using Aim NC-264-5 no clean flux. The boards have some
additional components installed by hand using water soluble flux/solder.
The boards are then run through our Aqueous Technologies SMT series board
washer. When they complete the drying cycle, there is a white residue on
the solder side of the boards that is very difficult to remove. Has anyone
else seen this residue from washing a board after using no clean flux? Does
anyone have any recommendations to help eliminate the residue?
Thomas P. Hummel
Carlton Industries Corp
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0 To
unsubscribe, send a message to [log in to unmask] with following text in the
BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet
NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send
e-mail to [log in to unmask]: SET Technet Digest Search the archives of
previous posts at: http://listserv.ipc.org/archives Please visit IPC web
site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|