I have been telling our employees that if they bleed they get fired (and we
are working with sharp metal sheets 1 - 25mil thick!)   ;)

In 13 years I have seen a few minor cuts and only one requiring 3 stitches.

Teach the personnel how to handle such materials.

Ahne.



-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of McGlaughlin, Jeffrey A
Sent: Tuesday, 10 July, 2007 04:23
To: [log in to unmask]
Subject: [TN] Injury by array

Oh wise and wonderful members of tech net -

We have had to incidents in the past six months where assemblers have been
cut while handling assembly arrays (2-up panels) for one of our products.
This has elevated the issue to "Panic Mode" due to the involvement of EHS&Q
(environmental health, safety and quality). As the designer of the array I
have been given ownership of the issue and am task with resolving it.  After
20+years of handling boards and arrays I have never been cut, so I am unsure
as to what if any corrective action can be taken to prevent future injuries.

The specifics on the arrays -
10.5" [267mm] x 12.0" [305mm] x 0.062" [1.6mm] thick
2 - up for 4.7"[119.3mm] x 9.2" [233.6mm] PCB Minimum rail 0.38"[9.5mm] Tab
Route and Retain (mouse bite) Injuries occurred during loading of the solder
printer and during slide line operations for post reflow assembly. 

Any suggestions on what to tell our production group?

Jeffrey McGlaughlin, CID
Engineering Designer
Battelle
505 King Avenue
Columbus Ohio 43201-2693
(614)424-7582 Phone
(614)458-7582 Fax
PS Don't you just love all those  management buzzwords (underlined.)
>;-D

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0 To
unsubscribe, send a message to [log in to unmask] with following text in the
BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet
NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send
e-mail to [log in to unmask]: SET Technet Digest Search the archives of
previous posts at: http://listserv.ipc.org/archives Please visit IPC web
site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------