Mime-Version: |
1.0 |
Sender: |
|
X-To: |
|
Date: |
Mon, 11 Jun 2007 12:11:58 -0500 |
Reply-To: |
|
Subject: |
|
Content-Transfer-Encoding: |
quoted-printable |
Content-Type: |
text/plain; charset="windows-1252" |
From: |
|
Parts/Attachments: |
|
|
Ron,
Your question, "Does anyone here have a sure fire way to combat insufficient
solder." apparently has two interpretations (1) how do I get sufficient solder
and (2) What should my inspectors do when there is insufficient solder. I'll try
to address the inspector issue.
Normally, inspectors do not cause rework. They have criteria from J-STD-001
and ANSI/IPC-A-610. Based on that criteria they will determine if an assembly
passes or fails the criteria. Unless that Inspector is quite experienced, a
Quality Technician or Engineer, or a Process Engineer determines what action
must be taken. Often "Insufficient Solder' is a process indicator. The process
needs improved, but the board does not need to be reworked.
Incidentally, I don't think that the term "Insufficient Solder" is in either
standard. I think that it is just a general term that we often use without
much definition.
Good Luck, Ron
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|