Weighting it down is only a band aid fix, maybe duct tape would help. Is it
possible to support the PCB and reflow/replace the BGA's? 

Is there a thermal issue that caused the bga's to be open or do you think
the flexing has created opens?  

Kat


-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Ron Peeler
Sent: Wednesday, April 25, 2007 3:23 PM
To: [log in to unmask]
Subject: [TN] BGA Weights

Hello TechNet

I was wondering is there anything in the industry that is used to weigh
BGA's down?  We are having an issue @ our shop with BGA's not soldering
effectively to one of our boards.  Currently we have a board that is suppose
to go through a boot process, however it has problems doing so.  The issue
is resolved when you press down in the middle of the BGA and fails again
once the BGA is released.  It doesn't help that our board warps easily as
well.  Is there anything, small gram weights or so that can weigh down a BGA
without shorting it?

Thanks

Ronald D. Peeler Jr., B.S. IE 
Process Engineer 
SWEMCO 
Moorestown, NJ 08057 
Tel: (856).222.9900 ext. 31 
Cel: (484).948.0779 
Fax: (856).222.0700 
[log in to unmask]

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------