It isn't in 6012 - the only rigid board spec it appears in is 6016.  

Do we need to add it to IPC-6012 for next revision?

Susan

Susan Hott
President
Robisan Laboratory, Inc
6502 E 21st Street
Indianapolis, IN 46219

317-353-6249 phone
317-917-2379 fax

www.robisan.com



-----Original Message-----
From: IPC-600-6012 [mailto:[log in to unmask]]On Behalf Of Chris
Mahanna
Sent: Tuesday, April 24, 2007 3:48 PM
To: [log in to unmask]
Subject: Re: [IPC-600-6012] peel strength


Mahendra,
Yep.  That's where I get the 1.05 N/mm (using the military rules for which number to use).  But, how is the requirement invoked -for foil lam conformance- from 6012?  If at all?
Chris

-----Original Message-----
From: IPC-600-6012 [mailto:[log in to unmask]]On Behalf Of Gandhi,
Mahendra (Space Technology)
Sent: Tuesday, April 24, 2007 3:27 PM
To: [log in to unmask]
Subject: Re: [IPC-600-6012] peel strength


Chris,
You need to look up IPC 4101 for this type of properties.

Mahendra 

-----Original Message-----
From: IPC-600-6012 [mailto:[log in to unmask]] On Behalf Of Chris
Mahanna
Sent: Tuesday, April 24, 2007 11:37 AM
To: [log in to unmask]
Subject: [IPC-600-6012] peel strength

Hi all,

I was recently ask to determine the conformance requirement for surface
peel strength on a commercialized military board (foil lamination
obviously).  Knowing that it was FR-4 I quickly replied 1.05 N/mm.  Then
I pulled up 6012 and searched for peel, with zero results.  ???  What's
up with that?

Thanks in advance,
Chris

Chris Mahanna
Quality Manager
Robisan Laboratory Inc.
6502 E 21st Street
Indianapolis, Indiana 46219
317.353.6249