Steve

Please post this picture on your web site. The Diode D116 pin 1 is 
represented by a white dot which is also the anode. I tried to tell the 
designers that the bar on the silk screen represents the cathode they would 
not listen so I wound up with major rework to correct all the misplaced 
(reversed) components. I was just call to the production line for yet 
another problem with F31 again footprint problems. This is why I asked the 
question if there exist a standard for creation of component foot prints. I 
do appreaciate all of your replies some have been most enlightening and will 
be passing this information along to the boards designers.

Gary Bremer
Manufacturing Engineer CIT - CID

_________________________________________________________________
Exercise your brain! Try Flexicon. 
http://games.msn.com/en/flexicon/default.htm?icid=flexicon_hmemailtaglinemarch07

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------