TECHNET Archives

February 2007

TechNet@IPC.ORG

Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
Wayne Thayer <[log in to unmask]>
Reply To:
TechNet E-Mail Forum <[log in to unmask]>, Wayne Thayer <[log in to unmask]>
Date:
Thu, 22 Feb 2007 12:44:21 -0500
Content-Type:
text/plain
Parts/Attachments:
text/plain (51 lines)
Dan-

Some board manufacturers do that deliberately to give the copper a nice
etched finish on the inside edge of the pad for a single sided job.  If
you drill through copper, it's common to have a bit of a burr left over
there which you either need to remove or convince the customer to
accept.

This should have been specified when the board was CAM'd prior to
sending it out.  Since you apparently didn't specify, I'd expect about a
3mil clearance there.  Getting tighter than that may raise the cost of
the board significantly.

Wayne Thayer

>>> [log in to unmask] 2/22/2007 11:40:47 am >>>
Good morning. Does anyone know of any acceptability criteria for "fish
eyes" or a thin void of copper around holes on single-sided boards? At
times there's a complete cirmcumfrential void and other instances
there's only a very small amount of copper missing. Thanks in advance
for any assistance!
Dan


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives 
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

ATOM RSS1 RSS2