Phil,

there are big chances that the assembly and PCB house do not communicate, unless you play the middle man. There was a thread yesterday on this, with very detailed inputs.

Just a thought,

Ioan

-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Phil Nutting
Sent: Tuesday, February 20, 2007 8:35 AM
To: [log in to unmask]
Subject: [TN] 0.5 inch breakaway rail on board edges


Good morning all,
 
For our PTH design boards we include a 0.5 inch wide v-scored rail on
all four sides.  These rails contain alignment holes for our Contact
Systems machines.  They also allow us to handle the boards through the
finger conveyor with components out to the edge of the finished board
and easily store in the board storage racks.
 
A question has been raised, for cost cutting reasons, if these are
really necessary for SMT design boards.  Should we just design them
one-up with no rails and let the fab house and CM work out the final
configuration?
 
Thanks in advance.
 
Phil Nutting

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------