Good afternoon everyone.  I hope your new year is going well so far.  I just
got off the phone with our folks in purchasing who were telling me that
there was a 13 week lead time for a resistor.  I checked a few places
on-line and was able to find a better (in terms of failure rate) resistor in
stock.  

 

My question is does anybody working with mil spec components have a blanket
substitution policy along the lines of "S or T failure rates can be used in
place of R failure rates without engineering approval" or do you require
approval for every sub?

 

Eric Kalgren

Electrical Engineer

Cobham Defense Electronic Systems 
Continental Microwave Division 
11 Continental Drive 
Exeter, NH  03833  USA
Tel:  603-775-5200  
Fax: 603-775-5201 
E-mail:[log in to unmask]  
Website:   <http://www.cobhamdes.com/> http://www.cobhamdes.com

 <mailto:[log in to unmask]>  

 


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------