Hello Fellow Technetters,
 
I'm having a problem with a Fuji GP-341.  
It has squeegee pressure control using a TD-320A comparator.
I cannot get it to measure printing pressure.
On the TD-320A it normally reads "2512" then flips to "oFl4" then back
to "2512".
If I perform the Printing Pressure Measurement steps from the GP 2/3
operation manual the reading goes to "2767" while the blade is down then
returns to the 2512/oFl4 reading.  After a short delay I get an error
message "PRESS SET L(R) NG" depending on which side I try to measure.
 
The books do not give much info on this system and Fuji wants me to
register the machine before technical support.  I wouldn't mind paying
Fuji if I knew they could solve the problem.  They have not been much
help on older machines lately.
 
Has anyone come across this before?  I'm hoping the TD-320A just needs
to be calibrated but I'm not sure.
 
Thanks for any help you can provide.
 
Jerry

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------