Subject: | |
From: | |
Reply To: | |
Date: | Fri, 1 Dec 2006 16:01:11 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Visualize 4 holes on a grid
1 2
3 4
everybody sections 1-2 or 1-3 etc -- the zero or the 90 degree (or nsew)
both directions run parallel and at right angles to the glass weave
the suggestion here is to section on the 45 (NE/SW/etc)
1-4 or 2-3 plane
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Victor G. Hernandez
Sent: Friday, December 01, 2006 3:11 PM
To: [log in to unmask]
Subject: [TN] RE: [TN] Re: [TN] Solder Voids in Hole barrel after W/S
I am unable to visualize the cross section being conducted. Clear the forest for me please.
Victor,
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Werner Engelmaier
Sent: Friday, December 01, 2006 1:55 PM
To: [log in to unmask]
Subject: [TN] Re: [TN] Solder Voids in Hole barrel after W/S
Thanks John,
I had not seen this either previously.
It certainly makes sense [oh 20/20 hindsight], that the 45°hole wall quality
would be different than the standard orthogonal ones.
Big question : Why should this be significantly different for the high-Tg
high-temp phenolic resin materials?-Any explanations, any one?
Werner
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|