Mornin' All!
 
Gary sent me a picture of his filter assembly so that you could see what he is talking about. The picture is at:
 
http://stevezeva.homestead.com/files/Filter.jpg
 
My thoughts are right along Brian's lines, it's heat transfer that's the key. Looking at the filters, it looks like they will suck the heat from too small a tip, so you will need a tip with some mass that will complete the joint successfully.
 
-Steve Gregory-

________________________________

From: Bremer, Gary [mailto:[log in to unmask]] 
Sent: Monday, October 23, 2006 4:21 PM
To: Steve Gregory
Subject: Filter assembly with pierced terminals



Steve,

 

Could you post this picture for me please.  Would like to have TechNet's recommended soldering iron temperature settings for this assembly, wire is 22AWG. My thought is to set the soldering iron to 600° Fahrenheit and hold for 1 - 2 seconds (until Sn63Pb37 solder flows and forms a solder joint).

 

Thanks,

Gary Bremer
Senior Manufacturing Engineer, CIT
Phone: 257-4430 extension 2170

 


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------