Buenos días,
Appendix A, # f of J-STD-001C said "Tip transient voltages generated by
soldering equipment should not exceed 2V peak". My question is: How do you
verify this?
We have a soldering iron tester that met the old MIL-STD-2000A
requirements. That is, we can measure the tip to ground voltage (2 mV RMS
max.)
Thank you in advance.
Juan T. Marugan
Indra Sistemas SA
Spain
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------