I asked the same question a few weeks ago. Looks like a typo to me. Two
volts is nuts.

-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Juan T. Marugán
Sent: Thursday, September 21, 2006 9:20 AM
To: [log in to unmask]
Subject: [TN] Solderin irons


Buenos días,

Appendix A, # f of J-STD-001C said "Tip transient voltages generated by
soldering equipment should not exceed 2V peak". My question is: How do you
verify this?

We have a soldering iron tester that met the old MIL-STD-2000A
requirements. That is, we can measure the tip to ground voltage (2 mV RMS
max.)

Thank you in advance.

Juan T. Marugan
Indra Sistemas SA
Spain

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------