Hi All,

I got a 10layer stackup as below,

Top  (1/2 oz+1/2 oz)
Inner1--gnd (1 oz)
inner2--signal 1 (1/2 oz)
inner3- pwr (1 oz)
inner4- gnd (1 oz)
inner5- signal 2 (1/2 oz)
inner6- pwr (1 oz)
inner7- signal 3 (1/2 oz)
inner8- gnd (1 oz)
Bottom (1/2 oz+1/2 oz)

if I divide this into two halves and see the prepreg tickness, core thickness both are equal. But if I look at the copper thickness the thickness is not balanced on either halves (4.5 oz on upper half and 4 oz on lower half). what issues this could cause in FAB and Assembly?

Can I mark this stackup as asymmentric?

Looking for your suggestions.

Thanks,
Nagaraj.






---------------------------------
 Here's a new way to find what you're looking for - Yahoo! Answers

---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
 Send FREE SMS to your friend's mobile from Yahoo! Messenger Version 8. Get it NOW