Genny,

We use Kyzen MX2501 in our vapor degreaser (NPB Free); and Kyzen Cybersolve for general hand cleaning. They work very well, but it depends on the customer requirements and the odor acceptability level the floor personnel can handle (of course they all are different). We switched from Ensolve to Cybersolve and MX2501 because of the odors; the NPB's in the chemistries; and costs. Now the odors are gone and our cleaning is just as good or even better depending on the situation. We to use no clean flux and the requirements are that the CCA's must be completely residue free, so these materials suit us very well.

Hope this helps.

Chris Schaefer
Suntron Corporation
Process Engineer
540 N. Rogers Road
Olathe, Kansas 66062
913.393.5878
[log in to unmask]

NOTICE:
 
This message is intended for the use of the individual entity to which it is addressed and may contain information that is privileged, confidential and exempt from disclosure under applicable law. If the reader of this message is not the intended recipient, or the employee or agent responsible for delivering the message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by calling 913.393.5878 or returning the original message to us.


-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Genny Gibbard
Sent: Thursday, May 18, 2006 12:59 PM
To: [log in to unmask]
Subject: [TN] Board wash


Hello all,
Do any of you use liquid board wash for spot-cleaning hand assembly
operations?
We have a bulk liquid we have been fond of and purchasing for years, but
recently the formulation had to be changed by the manufacturer, and it
is much more "aromatic" than it used to be.  Complaint volume is
increasing...
We are looking for alternative suggestions.
We use no-clean solder and flux, but we spot-clean flux added to
assemblies during hand-soldering operations, since it may not get fully
heated and rendered inert.

Thanks as always for your time.

Genny

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------