Look like we have a copper day today. Here is my question: what is the
surface finishing spec for copper pads (wire bonding pad with Ni/Au on
them)? I got extremely rough surface (look like sand blast surface) on my 2
layer substrate (1/2 oz on top and bottom). I have not seen such a rough
surface on the outter layer before, prepeg may be, not the surface
layer....Sure enough, I did not put restriction on the dwg note regarding
the surface roughness until I saw this puppy...Any spec or smart note I can
put on to prevent this? Thanks... (IPC standard gurus, any good clause
hidden in 20xx/60xx/70xx I can use?) Many thanks in advance.
Best regards,
jk
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------