You should check with the manufacturer of the connector to determine if they recommend it or have had any bad experiences.

-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Chris Ball
Sent: Thursday, April 20, 2006 8:03 AM
To: [log in to unmask]
Subject: [TN] potting over crimped terminations


Good Morning Geni-i,

An associate is looking for IPC reference material regarding potting over
crimped terminations.

Does anyone recommend anything other than: IPC/WHMA-A-620, Requirements and
Acceptance for Cable and Wire Harness Assemblies

Best Regards,
-Chris
-------------------------------------------------
   Chris Ball  (248)340-3023
   Expert - PCB Design Engineer
   Valeo CEE
   3000 University Drive
   Auburn Hills,MI 48326-2356
-------------------------------------------------


"This e-mail message is intended only for the use of the intended
recipient(s).
The information contained therein may be confidential or privileged, and
its disclosure or reproduction is strictly prohibited.
If you are not the intended recipient, please return it immediately to its
sender at the above address and destroy it."

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------