Good morning folks,
We've had some lively discussions regarding the best ways to measure scrap
within a manufacturing operation. What are some common ways of
characterizing and measuring accurate scrap levels?
Also, I know this next one is a loaded question but I'll fire it off
anyway. When scrap is measured as a percentage of sales, what values are
typical within this industry? One percent? Five percent? Is there a
significant difference between the value one would anticipate for a board
fab shop versus an assembly operation?
Brian Guidi
R&D/Quality Systems Specialist
Teledyne Printed Circuit Technology
Tel: (603) 889-6191 X:310
Fax: (603) 886-2977
E-mail: [log in to unmask]
Visit us @ http://www.tetpct.com