In a nutshell here is where i need some help:
we call out and enforce J-STD-001, Class 3 on our
assembly drawings. Very often we do repair/rework on
these assemblies and we do not seem to have a clear
link between IPC 7711 and IPC 7721 wherein the
how-to's and what to control are listed and J-STD-001,
Class3. The only words that address repair/rework in
J-STD-001 have to do with the acceptance criteria for
such operations.
Ques:
1. I am reading this correctly?
2. How do i ensure that the repair and rework
procedures and the skill sets are adequate? do I need
to explicitly state in on the drawing the need for
repair and rework per IPC 771 and IPC 7721?
3. If i do not state that then is the compliance to
J-std-001 violated?
Thanks
Prasad Godavarti
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------