Subject: | |
From: | |
Reply To: | |
Date: | Fri, 21 Apr 2006 19:21:37 EDT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
In a message dated 4/21/06 17:47:28, [log in to unmask] writes:
> Just a quick question. What are you speaking of below when you suggest
> eliminating solder fillets on the end caps? Aren't those fillets necessary for
> reasons of reliability?
>
Hi Leland,
This is a common misconception--and goes way back to ceramic leadless
castellated chip carriers. What the fillets do is pull the component down to the PCB
soldering pad because of solder surface tension, thus minimizing the solder
joint height. Increased solder joint height reduces the strains experienced by
the solder from a given thermal expansion displacement. Thus, in chip
components as in leadless chip carriers, the SJ underneath the component fractures
relatively early [much earlier for the larger chip carriers]; what the fillets do
provide is solder volume through which the crack more or less slowly
propagates--but this really is a Band-Aid approach. Much more reliability can be
achieved with the proper SJ height; see BGAs and CGAs neither of which has solder
fillets.
Reducing the PCB pad size allows the chip component to swim up on the liquid
solder [now surface tension works to your benefit]—better yet is gluing the
components down and let the high CTE of the adhesive lift the components away
from the PCB during the soldering process thus increasing the SJ height, and
thus increasing fatigue reliability.
Regards,
Werner Engelmaier
Engelmaier Associates, L.C.
Electronic Packaging, Interconnection and Reliability Consulting
7 Jasmine Run
Ormond Beach, FL 32174 USA
Phone: 386-437-8747, Fax: 386-437-8737, Cell: 386-316-5904
E-mail: [log in to unmask], Website: www.engelmaier.com
|
|
|