In a message dated 3/20/2006 4:16:28 P.M. Pacific Standard Time,
[log in to unmask] writes:

I would  love to see some cross-section pictures of the plating of a
punched  hole  near the _end_ of a production run :)


I would like to also, George...

If you can recall and don't mind sharing the info, what was he minimum hole
size you punched and what was the maximum number? Also what minimum spacing
was  allowed?

Thanks.

Kind regards,
Joe

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------