I once programed a robot for soldering but it went crazy and kept saying
"DANGER DANGER"
I had to pull it's battery pack then...
Ken
--------------------------------------------
Kenneth J. Wood C.I.D.
Saturn PCB Design
www.saturnpcb.com
407-340-2668
----- Original Message -----
From: "Black, Paul" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, February 13, 2006 11:24 AM
Subject: [TN] Robots


Hi Everyone,

I was wondering if anybody has used a robot for SMT placement. I have a few
SMT connectors that can't be placed by my older SMT equipment and I could
never justify new equipment just for these parts. We are hand placing some
of the parts right now, but there is a new board on the horizon that is not
layed out well for hand placing a .020" pitch connector, so I'm thinking
that a low cost robot (is that an oxymoron?) might work. Any thoughts or
experiences?

Thanks in advance.

Paul Black
Manufacturing Engineer
Kronos
E-mail: [log in to unmask]
Voice: (978) 947-1520

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------