Hi Scott,
I can't recommend a material, but I have used this site to see if materials
are NASA approved (low outgassing)
http://outgassing.nasa.gov/
Good Luck!
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Scott Decker
Sent: Friday, February 10, 2006 9:56 AM
To: [log in to unmask]
Subject: [TN] Via fillings question.
OK, fillings may sound like a dental term, but I mean via plugging
materials. :-) I'm looking for what materials I can use to plug a .010"
via and meat NASA specs for out gassing, etc. I have some names so far, but
no data on if they are approved for space apps. The names are so
far:
Peters fill (maybe this is a spec number, SD2795?) and is non-conductive?
CB100, which I know is OK for space and conductive, but FAB would need a
jack hammer to get it in a .010" hole so that's out.
And last I have is San-IE, which I understand is non-conductive and supposed
to be good in space, but San-IE what?
For this project I don't need conductive but they will be under a BGA so it
will need to be flat and covered with solder mask. I got that part covered,
(no pun intended) but I just need to know what to call out on my drawing.
Any help would be great.
Later.
Scott Decker
AKA: Padmasterson
Broad Reach Engineering CAE
Ph. 480-377-0400 Ext. 34
FAX. 480-968-4597
Tempe, AZ.
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e To
unsubscribe, send a message to [log in to unmask] with following text in the
BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet
NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send
e-mail to [log in to unmask]: SET Technet Digest Search the archives of
previous posts at: http://listserv.ipc.org/archives Please visit IPC web
site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
