Hi Ivan! Metal dissolution rates are temperature specific - one of the most
often quotes sources is:
W. Bader, "Dissolution of Au, Ag, Pd, Pt, Cu and NI in a molten tin lead
solder", Welding Journal 48, 1969, pp. 551-557
Also this paper has the dissolution rate of copper in a variety of solder
alloys:
W. Bader, " Lead alloys for high temperature soldering of magnet wire",
Welding Journal 54, 1975, pp. 370-375.
Hey John Barnes - any other sources you can add?
Dave Hillman
Rockwell Collins
[log in to unmask]
Ivanoe Pedruzzi
<i.pedruzzi@LABEL
GROUP.COM> To
Sent by: TechNet [log in to unmask]
<[log in to unmask]> cc
Subject
01/16/2006 04:38 [TN] Dissolution rates and solder
AM paste selection
Please respond to
TechNet E-Mail
Forum
<[log in to unmask]>
; Please respond
to
Ivanoe Pedruzzi
<i.pedruzzi@LABEL
GROUP.COM>
Back on dissolution metals in molten solder, I remember reading on an
e-mail the following dissolution rates:
Dissolution rates
Au = 117.9 u"/sec.
Ag = 43.6u"/sec.
Cu = 4.1 u"/sec.
Pd = 1.4 u"/sec.
Ni = 0.05u"/sec.
Pt = 0.01 u"/sec.
At which temperature of the molten solder these dissolution rates
are applicable?
If I use those numbers to set up the TIME ABOVE LIQUID temperature
profile in a reflow oven, I'm not doing anything but the right thing,
am I ?
I also remember reading something about flux in the solder paste that
should be able to withstand that change (either longer time, or
higher temp, or both).
Upon your experience, is that practical? I don't remember any solder
paste representative talking about "...this paste for this plating,
that paste for that plating...". Do you?
Thanks, Ivan
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|