Subject: | |
From: | |
Reply To: | |
Date: | Wed, 11 Jan 2006 17:19:37 +0100 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Terry,
Did you get any respons? Interesting finegrade work. But your project
seems little 'homebuilt' or more correct an emergency solutions.
Depending on how large your board is, I would use a 'Gregory' solution,
i.e. kind of a twin flat steel (for ovens)band, bend both ends to small
hooks and bend the hole to a low 'V' which will force the pieces against
each other. If the band goes continously from PP to oven it may be a
less good idea.
ELCO makes these connectors.
Inge
-----Ursprungligt meddelande-----
Från: TechNet [mailto:[log in to unmask]] För Terry Kozlyk
Skickat: den 5 januari 2006 17:34
Till: [log in to unmask]
Ämne: [TN] SMT Connector Assembly Question
Technet;
I have a fine pitch single sided 50 pin edge connector to assemble onto
the edge of a PCB. It overhangs the PCB edge.
This is a SMT which is pick & placed from a reel.
Actually this is a single-sided 50 pin Compact Flash Connector from AVX
Series 5611 Receptacle Connector.
This PCB is panelized. This connector has 2 supports on each side but
the support plane is at the same Datum as the PCB bottom side
( DATUM A).
So the panel must have a milled out pocket for this connector to sit in.
Question is;
What is the best way to support this connector during pick & place, then
into reflow?
The pocket above is only a clearance & provides no support to hold the
connector in place.
The only thing I see now is having a bare FR4 panel underneath this PCB
to provide support for the connector.
Any thoughts are much appreciated.
Regards
Terry (TDK)
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|