I'm getting "LAM VOIDS" on a 16 layer board that we build.
The board is .140" thick and has 2 oz copper on layers 2,
8, 9, and 15. Any ideas on what might be causing these "LAM
VOIDS". The "lam voids" are about .004" x .010" in size and
x-sections show them between different layers such as the
surface of layers 2, 6, and 11.
I just began looking into this issue so I'll appreciate any
ideas.
Thank you,
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------