Good afternoon,
Has anyone started to change over small solder pots used for wire
tinning from tin/lead to lead free?
What alloy and flux has you found to be best?
I'm planning to run SAC305 in my wave solder pot, so using the same
would be convenient, but not essential.
Using an RA or RMA flux probably would be best.
The primary function of these solder pots is for tinning Litz wire (many
fine strands of individually enamel coated wires) for inductors.
All suggestions are welcome.
Phil Nutting
-------------------------------------------------------------------------------Leadfee Mail List provided as a service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Leadfree
To temporarily stop/(start) delivery of Leadree for vacation breaks send: SET Leadfree NOMAIL/(MAIL)
Search previous postings at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-------------------------------------------------------------------------------