TECHNET Archives

November 2005

TechNet@IPC.ORG

Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
"Bloomquist, Ken" <[log in to unmask]>
Reply To:
TechNet E-Mail Forum <[log in to unmask]>, Bloomquist, Ken
Date:
Mon, 7 Nov 2005 10:59:35 -0800
Content-Type:
text/plain
Parts/Attachments:
text/plain (32 lines)
Hi Ramon,

It's been quite a while since we did this but to the best of my
recollection (it's tough getting older)I believe we applied conformal
coating to component ID after reflow and before any wet processing.

KennyB

-----Original Message-----
From: Dehoyos, Ramon [mailto:[log in to unmask]] 
Sent: Monday, November 07, 2005 10:49 AM
To: TechNet E-Mail Forum; Bloomquist, Ken
Subject: RE: [TN] Component marking on metal parts...

        Hi Kenny:
                        Didn't the CC discolored, or better yet darkened
after the reflow oven? I ask this question since the baking temp for CC
is a lot lower than the reflow temp. I am all for it, if it works. I am
just curious.
        Regards,
        Ramon 

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------

ATOM RSS1 RSS2