Subject: | |
From: | |
Reply To: | |
Date: | Fri, 7 Oct 2005 12:19:13 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
The company I work for is going thru some documentation change
discussions.
Below are the documents that are revisable. (The parts list contains all
the IC's, cap, res. etc. and documents.)
The feedback I'm getting is the the parts list and the assembly drawing
should ALWAYS be the same revision (becasue thats the way its always
been).
Everywhere I've every worked, these are independent documents.
Here are my scenerio case: (All documentation released at Rev. A)
Scenerio (Rev: B): A part number change, of a 1K, 5% resistor to a 1K,
1% resistor.
In this case, the part list and schematic would change, but it has no
effect on the assembly (because no part number or value is on the assembly
drawing).
PL1234567-1 Rev: B Parts List
AW1234567 Rev: A Assy Dwg
DS1234567 Rev: A Drill Dwg
PC1234567 Rev: A Artwork
PA1234567 Rev: B Schematic
Scenerio (Rev: C): The length of the screw holding the stiffener bar is
changed from 3/8 in. to 1/2 in.
The change is to the parts list only, the assembly drawing stays the same.
(no 3D view or side view)
PL1234567-1 Rev: C Parts List
AW1234567 Rev: A Assy Dwg
DS1234567 Rev: A Drill Dwg
PC1234567 Rev: A Artwork
PA1234567 Rev: B Schematic
The current discussion and question is;
-Can the parts list be independently revisible, from the assembly drawing?
-What do most of the assembly houses usually like?
Thanks for any response to this question.
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
[log in to unmask]
|
|
|