This is not a normal process. I would think that chemical etching is
more affective in removing metals and oxides from the resin surface.  We
see no issues with SIR/MIR using standard PCB processes.  I have done
this in the past of flex to promote stiffener bonding and mask adhesion.
Possible the PCB house has an issue with chemical etching or base
materials.  

Jeffrey Bush
Director, Quality Assurance and Technical Support

VERMONT CIRCUITS INCORPORATED
  76 Technology Drive - POB 1890
    Brattleboro, Vermont 05302
      Voice: 802.257.4571.21 Fax: 802.257.0011
           http://www.vtcircuits.com
 

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Ivanoe Pedruzzi
Sent: Tuesday, September 06, 2005 9:35 AM
To: [log in to unmask]
Subject: [TN] Sand blasting pcb after copper etching

Dear Technetters,

I'm not familiar with the process of making pcb and I would like to
have your comments on something I was told from a pcb maker
representative.

"...in order to ensure a well insulation between traces, we do
sandblasting (very little and tiny) pcb's after etching.
this is to remove the bonding material that remains on the board after
removing the copper. This is the only way to achieve a very good SIR
result."

Is this a normal procedure, was he correct in his claim?


Thanks,
Ivanoe Pedruzzi

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------