Subject: | |
From: | |
Reply To: | |
Date: | Wed, 21 Sep 2005 12:18:36 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Bill,
This is good information.
Thank you.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of [log in to unmask]
Sent: Wednesday, September 21, 2005 11:40 AM
To: [log in to unmask]
Subject: Re: [TN] Fused tin lead plating versus HASL
There are a couple things to watch with this, esp. if solder-masked
after IR fusing. Often saw problems with this process if UV cured
liquid solder mask used. If output of UV lamps not monitored, only a
partial cure results in a weak mask*. Then when soldering takes place,
the tin-lead under the mask melts and moves, tearing the thin weak
mask. Then as the PWA cools, flux residues suck under the mask through
the minute tears in the mask. Such entrapped residues leak out over
time, possibly compromising the reliability of the PWAs.
Readers should be aware that the fusing fluids are essentially strong
water soluble fluxes which can have a significant negative impact on the
SIR of the completed assemblies. Such results have been reported at
China Lake Soldering Seminar and Internepcon Japan. So now one could
potentially have water soluble fluxes and assembly fluxes seeping out
through the minute solder mask tears. This could often be detected by
the ionic contamination levels not going to zero during the duration of
the test, or by continuing to show high levels if the ionic testing is
repeated.
*UV lamps start to degrade the minute they are turned on, in contrast to
incandescent lamps. One published example stated that three passes
through the UV solder mask curing cycle were needed to reach the desired
level of solder mask cure.
Bill Kenyon
Global Centre Consulting
3336 Birmingham Drive
Fort Collins, CO 80526
Tel: 970.207.9586 Cell: 970.980.6373
email: [log in to unmask]
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e To
unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or
(re-start) delivery of Technet send e-mail to [log in to unmask]: SET
Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the
posts: send e-mail to [log in to unmask]: SET Technet Digest Search the
archives of previous posts at: http://listserv.ipc.org/archives Please
visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for
additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|