Fellow netters, a question about class 3 flexi film annular ring
requirements. I'm told that in rev G of IPC-A-600 the min annular ring
requirement is 0.002" around the circumference, whereas in the previous
rev F (which is the copy I have) the min annular ring was 0.005". Is the
0.002" figure correct and if so, what was the rationale behind the
reduction?
Regards
Ian Fox
Goodrich ECS
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------