Subject: | |
From: | |
Reply To: | |
Date: | Wed, 13 Jul 2005 11:30:00 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Kenny,
As mentioned in another mail, Hepco is always a good choice. I have
also had very good luck with Streckfuss trimming equipment, and they can
work to develop custom plates if they don't have a standard plate
already in production. I'm sure Google can give you contact info.
Good Luck, at least this is one of those problems that just takes a bit
of money to solve, and isn't too technically challenging!
Hal
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Bloomquist, Ken
Sent: Wednesday, July 13, 2005 10:16 AM
To: [log in to unmask]
Subject: [TN] Connector Lead Trimming
Good Morning Technetters,
We have some 15 and 25 pin D-sub connectors that we need to trim the
leads. They are .030" phosphor bronze and we only need to trim about
.020 - .030 from the ends.
Does anybody know of some good reliable, low maintenance trimming tools
that would work good for this application? I want to trim them pre wave
solder, not post solder with a bologna slicer.
Thanks,
KennyB
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text
in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at:
http://listserv.ipc.org/archives
Please visit IPC web site
http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100
ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|