Subject: | |
From: | |
Reply To: | |
Date: | Mon, 6 Jun 2005 09:45:04 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Roger:
Try CCR1000/CCR2000 cutting media at 800.443.2726. This media only creates charges less than 50 volts. Others you mention charge up to several thousands volts. I have done extensive work on blasting with corn starch, as you say the powder gets everywhere and needs to be removed. The CCR type is made of a man made material that is treated so it does not create charges and blows off easily.
Regards,
Ramon
-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Roger Mack
Sent: Friday, June 03, 2005 1:29 PM
To: [log in to unmask]
Subject: [TN] micro abrasive blasting for conformal coating removal
Has anyone used one of the micro shot blasting systems for removal of
conformal coating?
I have some concerns about static and the residue left behind. We use a
moisture cure silicone coating, so abrasion works well to remove it, but the
dry powder in the air stream must produce high static charges and if it is
not possible to wash the assembly the shot residue will be left behind.
There are multiple different shot materials offered including walnut shell,
plastic pellet, and sodium bicarbonate. Since powders are difficult to
remove from the soft silicone coating, are there any of these materials that
a trace residue left behind would not cause reliability issues?
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|