Subject: | |
From: | |
Reply To: | |
Date: | Tue, 21 Jun 2005 08:13:50 EDT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Copper plating thickness distribution between the surface and the middle of
the thru hole needs a little more definition, than what you have mentioned.
If the aspect ratio (board thickness/ hole diameter) is 3 or less, meeting
1.0 in the hole and 1.2 on the surface is an acheivable task.
If the aspect ratio is 5 or greater it becomes more challenging.At 10:1
aspect ratio the shop needs to use a hi throw plating bath, and the plating current
must be dropped to as low as 10 ASF with a minimum of 2 hours of plating.
The aspect ratio must be included in the specification of thickness
distribution, between the hole and the surface.
I hope this helps.
Best regards
George Milad
National Accounts Manager for tTchnology
Uyemura International Corporation
240 Town Line Rd
Southigton, CT06489
860 793 4011 (O)
516 901 3874 (cell)
[log in to unmask]
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|