All!
We have a customer that has had a design that we did quoted for 1000 pieces
by a fab vendor.
We have a .013 finished hole with a .024 pad. We're saying that that is not
a DFM problem. Any "GOOD "vendor should not choke on this.
What say you?
Thanks
Deac
KAW/USA
Director, Business Development
39 Simon Street, Suite 4
Nashua, NH 03060
phone: (603) 886-8711 ext.202
fax: (603) 881-8763
Cell : (603) 557-7568
Web sites:
www.kaw.com
www.emistream.com
"Real People .... Real Solutions ..... Real Success"
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------