Subject: | |
From: | |
Reply To: | |
Date: | Tue, 17 May 2005 11:09:20 +0100 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
For starters, get rid of all unnecessary bits, like component outlines, the boxes around SMT resistors etc.
Hardly needed when the component is fitted & when fitting them a component assembly drawing aids fitting.
Then you might have more room for polarisation marks.
Matthew.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of Green, Mike
Sent: Tuesday, May 17, 2005 1:20 AM
To: [log in to unmask]
Subject: [TN] Markings
As boards get denser, we are having more and more difficulty, locating markings on our boards without encroaching on lands. Sometimes it is even difficult to locate the pin 1 orientation marks. We use can the drawing to clarify some places, but this is not always a solution. Most of our designs are extremely low volume, so we cannot use a learning curve figure it out. How do you resolve this conflict?
Mike Green
Lockheed Martin Space Systems
1111 Lockheed Martin Way
Sunnyvale, CA 94089
office 408-743-1635
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|