We use Cadence Allegro, "IPC-356" can be extracted during output.
On the fab drawing we have a note:
#12. Perform Electrical netlist testing on all PWBS per IPC-D-356 netlist
provided. If netlist provided does not match artwork during fabrication
front
end job setup, stop job, and call Catapult.
We do up to 30 layer, low volume. I would hate to build anything that didn't
match. All I got to say is "Time and money"
dave
Roland Jaquet wrote:
>It sounds so good..
>
>Unfortunately, so little companies are even conscious of the advantage of
>the IPC-356.. and if the CAD software does not yet automatically supply it,
>please request it.
>
>Any idea of the percentage of PCB orders that are using IPC-356 ???
>
>Can PCB manufacturers give an idea of the percentage of jobs they get with
>it???
>
>I seen Electrically Tested PCB's that were missing an inner layer... because
>they used the Golden board approach...
>
>
>Very Best regards
>Rol@nd
>
>www.PCBspecialist.com
>T +41-22-880-0405 F +41-22-880-0409 Mob +41-79-203-3723
>
>
>-----Message d'origine-----
>De : TechNet [mailto:[log in to unmask]] De la part de Dave Seymour
>Envoyé : mercredi, 6. avril 2005 15:57
>À : [log in to unmask]
>Objet : Re: [TN] Golden Board Electrical test
>
>To add Marsal response.
>
>The golden board goes through shorts and opens test,
>visual QC and then passed. This board the becomes the
>reference that all other boards are then check by.
>
>However, this not an electrical netlist test.
>If the generated Gerber artwork had an error during output at
>the design phase, the artwork produced may not match the intended
>schematic.
>
>At this point all boards match each other and are declared "good",
>But, the boards don't match the schematic.
>
>This is the reason for the "IPC-356" netlist being included with all
>jobs going to fabrication. All designs that leave our shop must have
>an extract IPC-356 netlist for the fab shop to verify artwork shipped.
>
>Hope this helps.
>dave
>
>
>
>
>Marsal Tampubolon wrote:
>
>
>
>>Hi Suganthi..
>>In other words, golden board also call as KGB
>>(Known Good board ). Sometimes also call as reference
>>board. Meaning it is the sample board that being
>>pass test if there is electrical test conducted or
>>pass visual test. This board will using for set
>>up tester before run to mass production test or during
>>comparison for troubleshoot board defect from the same
>>model.
>>
>>****************************************************
>>Regards...
>>Marsal GM Tampubolon.
>>
>>
>>|---------+---------------------------->
>>| | Suganthi |
>>| | <suganthi@CG-CORE|
>>| | EL.COM> |
>>| | Sent by: TechNet |
>>| | <[log in to unmask]>|
>>| | |
>>| | |
>>| | 06-04-05 04:30 PM|
>>| | Please respond to|
>>| | Suganthi |
>>| | |
>>|---------+---------------------------->
>>
>>---------------------------------------------------------------------------
>>
>>
>-------------------|
>
>
>> |
>>
>>
>|
>
>
>> | To: [log in to unmask]
>>
>>
>|
>
>
>> | cc:
>>
>>
>|
>
>
>> | Subject: [TN] Golden Board Electrical test
>>
>>
>|
>
>
>>---------------------------------------------------------------------------
>>
>>
>-------------------|
>
>
>>
>>
>>
>>
>>Dear All,
>>
>>
>>
>> please explain me what is "Golden Board" electrical test
>>
>>
>>
>>Thanks and Regards
>>
>>
>>---------------------------------------------------
>>Technet Mail List provided as a service by IPC using LISTSERV 1.8e
>>To unsubscribe, send a message to [log in to unmask] with following
>>text in
>>the BODY (NOT the subject field): SIGNOFF Technet
>>To temporarily halt or (re-start) delivery of Technet send e-mail
>>to [log in to unmask]: SET Technet NOMAIL or (MAIL)
>>To receive ONE mailing per day of all the posts: send e-mail to
>>[log in to unmask]: SET Technet Digest
>>Search the archives of previous posts at:
>>http://listserv.ipc.org/archives
>>Please visit IPC web site
>>http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional
>>information, or contact Keach Sasamori at [log in to unmask] or
>>847-615-7100 ext.2815
>>-----------------------------------------------------
>>Sug
>>
>>---------------------------------------------------
>>Technet Mail List provided as a service by IPC using LISTSERV 1.8e
>>To unsubscribe, send a message to [log in to unmask] with following text in
>>the BODY (NOT the subject field): SIGNOFF Technet
>>To temporarily halt or (re-start) delivery of Technet send e-mail to
>>
>>
>[log in to unmask]: SET Technet NOMAIL or (MAIL)
>
>
>>To receive ONE mailing per day of all the posts: send e-mail to
>>
>>
>[log in to unmask]: SET Technet Digest
>
>
>>Search the archives of previous posts at: http://listserv.ipc.org/archives
>>Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
>>
>>
>for additional information, or contact Keach Sasamori at [log in to unmask] or
>847-615-7100 ext.2815
>
>
>>-----------------------------------------------------
>>
>>
>>
>>
>>
>>
>
>--
>Dave Seymour, CID+
>Catapult Communications Inc.
>800 Perimeter Park Dr, Suite A
>Morrisville, NC 27560
>
>Direct: (919)653-4249
>Main: (919)653-4180
>Fax: (919)653-4297
>
>[log in to unmask]
>
>---------------------------------------------------
>Technet Mail List provided as a service by IPC using LISTSERV 1.8e
>To unsubscribe, send a message to [log in to unmask] with following text in
>the BODY (NOT the subject field): SIGNOFF Technet
>To temporarily halt or (re-start) delivery of Technet send e-mail to
>[log in to unmask]: SET Technet NOMAIL or (MAIL)
>To receive ONE mailing per day of all the posts: send e-mail to
>[log in to unmask]: SET Technet Digest
>Search the archives of previous posts at: http://listserv.ipc.org/archives
>Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
>for additional information, or contact Keach Sasamori at [log in to unmask] or
>847-615-7100 ext.2815
>-----------------------------------------------------
>
>---------------------------------------------------
>Technet Mail List provided as a service by IPC using LISTSERV 1.8e
>To unsubscribe, send a message to [log in to unmask] with following text in
>the BODY (NOT the subject field): SIGNOFF Technet
>To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
>To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
>Search the archives of previous posts at: http://listserv.ipc.org/archives
>Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
>-----------------------------------------------------
>
>
>
>
--
Dave Seymour, CID+
Catapult Communications Inc.
800 Perimeter Park Dr, Suite A
Morrisville, NC 27560
Direct: (919)653-4249
Main: (919)653-4180
Fax: (919)653-4297
[log in to unmask]
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
